Guild of Writers

Posted: **Tue Jul 01, 2008 7:46 pm**

Also this means there's more scalability.

'cause not everyone is going to have 4gigs of ram (most likely you'd need this with the non-paging system and filled shells).

Posted: **Wed Jul 02, 2008 12:28 am**

D'Lanor wrote:
Grogyan wrote:I have noticed virtually no difference between the 0.8c and 0.8d version, it still takes about 20 seconds to get in.

In that case you did not have a problem to begin with. A load time of 20 seconds is already pretty decent for a large age. This optimized version will mostly benefit those who had to wait several minutes for Pahts to load or could not load it at all.

That may have something to do with my 2Gb of 800MHz of RAM.

Its still not enough as I was doing something with Blender the other night, and it far exceeded that and crashed
I wasn't doing any rendering just in case you were wondering

Posted: **Wed Jul 02, 2008 4:07 am**

Grogyan wrote:That may have something to do with my 2Gb of 800MHz of RAM.

Its still not enough as I was doing something with Blender the other night, and it far exceeded that and crashed
I wasn't doing any rendering just in case you were wondering

Are you using Blender 2.46? I have similar Blender problems after I switched to the new version. Maybe the Blender devs should consider paging... :lol:

Posted: **Wed Jul 02, 2008 5:24 am**

Hmm, maybe you should split your age up into separate blends--and prps(for Cyan each max file is a prp).

~Lontahv

Posted: **Wed Jul 02, 2008 11:40 am**

I don't know if you saw Prad but the size of the age is hardly the problem there. :lol:

Guild of Writers

Ahra Pahts Release With Paging

Re: Ahra Pahts Release With Paging

Re: Ahra Pahts Release With Paging

Re: Ahra Pahts Release With Paging

Re: Ahra Pahts Release With Paging

Re: Ahra Pahts Release With Paging