Freeze After Loading in Uru

[Floydman]

I'm not sure if this is a PyPRP problem or not, but I figure this is as good a place as any to report my problem. My Age exports out of Blender fine using v1.4.0 of the plugin, but when I link to it in Uru my computer freezes. It doesn't crash to the desktop or anything, and I am forced to cancel the process using the Task Manager. My Age has a unique Sequence Prefix, and I am able to load Ahra Pahts without any trouble (this is a separate age, not a shell).

[andylegate]

If you have loaded the Age before this time, try going to your sav folder and deleting the sav file for that Age, then try loading up and linking in again.

Can't offer any other help, unless you have other info about the crash/age/install

[Lontahv]

Ok, this is going to sound dumb but:

Does it have a valid SpawnPoint named "LinkInPointDefault" and what were you exporting your age with before (we use 'type:swpoint' in GoWpyprp but in alcugsPyprp they used 'alctype:swpoint')?

I dunno, it sounds like you're linking to nowhere. This could be a ULM fluke.

~Lontahv

[Floydman]

I have never exported this particular age before, and this is my first export with v1.4. I have a LinkInPointDefault that is placed 10 units above the ground.

[Tsar Hoikas]

Are you running in fullscreen?

Uru is a a fullscreen hog and may be hiding a stack dump (which would provide the right person with a lot of information)... Try using windowed mode and see if you get a stack dump.

[Floydman]

No stack dump, but the Page Faults Delta is about 6 a second.