from SUBWORLD to 'real world'

[ametist]

I have this problem with going(walking) from my subworld to the 'real world'. I have read the earlier posts about subworlds and 'ekkimai' had a similar problem. She(or he) solved it by letting all objects have the same coordinates. I have that with all objects except the bridge which has the same x and z coordinates anyway. but I still fall through the age when walking off the subworld collider to the real world.
The subworld itself works fine, I can step on to my little boat and take a ride by clicking it, it lands correctly to the bridge after the ride, I step off the boat allright, walk a bit on the bridge allright BUT when I take that step off the colliderplane to the bridge I fall.
Here is a pic of the objects:

Show Spoiler

(The collider ends at the cursor point.)I have tried a lot of combinations with the bridge -no bridge, boat landing directly on the shore, bridge smaller, bridge wider and so on. I have let the exitregion be 0.5 above collider, I have let the bridge be 0.5 above the collider - no luck. D'Lanor wrote about 'smart seek' but I don't know where that variable should be placed in the script if that's the problem?
Any ideas where to make changes with this to make it work? Thanks!

[D'Lanor]

My problem with smartseek was that my subworld is in constant motion.

Your exit region encompasses the entire subworld. Did you use the onexit parameter in your exit region alcscript?

[ametist]

Thanks D'lanor! Yes, here is that part of the alscript:

Show Spoiler

and here's the rest of it:

Show Spoiler