Page 1 of 1

Problems with my Elevator

PostPosted: Wed Nov 30, 2016 8:21 am
by Dulcamara
Hello all

in my new Age i have a elevator. (nothing new becouse there is one in ElodeasTunnelgang and Schatzkammern too). But this time i have a new problem.
I go into the elevator, all is ok . I drive downward, all ok. If i want to go out of the elevator i go one step that is ok , but then i fall down and must go to Relto.
Who can help me with this problem ?


Greetings
Dulcamara

Re: Problems with my Elevator

PostPosted: Wed Nov 30, 2016 12:24 pm
by dendwaler
I recognize that as a common problem with enter and exit regions.
I completely gave up with my rising organ in the cathedral , originally i wanted that you could use that subworld to travel down to the cellars.
Anyway, you can try to make a second collider just a bit below the one where you exit. Then you fall down on this collider.
But if you place the collider not exactly horizontal , you walk a little upwards and come back on the correct height.
This sometimes works if the exit zone is only in one direction.
If the exit is round and therefore had more adjacent planes. It still didnot work on the edges.

Re: Problems with my Elevator

PostPosted: Thu Dec 01, 2016 6:17 am
by Dulcamara
Hello Dendwaler,
thanks for your answer. I will try it with the Collider.
If it will not work, i must build many stairs and ladders :lol: :lol: ,
to get to the desired location.

Dulcamara

Re: Problems with my Elevator

PostPosted: Thu Dec 01, 2016 12:36 pm
by Karkadann
Linking books might work

Re: Problems with my Elevator

PostPosted: Fri Dec 02, 2016 6:15 am
by Dulcamara
Thanks Karkadann for your response :)


I have no experience with linking books in the same age. :oops:

I will see what is the best for ours explorer.
I think a little movement can not hurt. :lol:
Why always use the elevator when stairs are so healthy.
The last alternative would be to jump from the top to the ground.

Re: Problems with my Elevator

PostPosted: Fri Dec 02, 2016 3:21 pm
by Jaruku`
Look at the floor or collider of the elevator that has the bounds set and how far it protrudes into the target floor's collider. it must protrude at least one foot or more. the elevator floor or collider must be slightly above that floor. I believe this is a common problem with subworlds which has plagued me as well. Also check your subworld itself and make sure that the X and Y axis in transform properties rotation are set at 0. Hope this helps.

Re: Problems with my Elevator

PostPosted: Sat Dec 03, 2016 12:06 pm
by Dulcamara
Yeah Jaruku :) :) :)

you are my absolute hero. I think it works.

Thats great.

Thank you very, very much.

Also you Dendwaler and Karkadann, I would like to thank you for your help.