I have not added this to the Korman wish list because I wanted to run this past those that support scripted stuff like the Ladder tool before it became a Korman thing.
Here I am thinking a generic door tool with the following options.
Door type
Single Swing towards Left hinge
Single Swing towards Right hinge
Single Swing away Left hinge
Single Swing away right hinge
Double swing towards
Double Swing away
[edit]
Drawbridge bottom hinge down towards
Drawbridge bottom hinge down away
Drawbridge top hinge up away
Drawbridge top hinge up towards
Bat-wing saloon doors
Split farmhouse door
[/edit]
Slab door descend
Slab door ascend
Slab door slide Left
Slab door slide right
Slab Biform horizontal slide (Think of double door lift in Gahreesen)
Slab Biform vertical slide (Think as above but half descends half ascends)
If possible an iris door
Door activation options
Door opens on approach
Door opens when some button is clicked
Door opens dependent on some other state (power switched on somewhere)
Door persistence options
Close delay
Stay open
With or Without passage through door animation.
For now this is about all of the options I am throwing around for consideration.
Other things for consideration
On a personal note I would like the door to have a partway open option where you can see beyond but not actually pass here I am really thinking about a door that is only Slab door descend and I would like a door that had two status switches one a variable (number) and two the status of another door that was Slab descend that completes by being stomped on.
I would also like a Slab door ascend that sticks partway and can have a crawl under animation.
How about a partially open Biform horizontal slide that opens only enough to let a Female Avatar pass with the appropriate animation but not a Male but with a switch or some other state change on the far side that would allow for complete opening this would (pardon the pun) leave the door open for co-operative puzzles.
All or none of this may be possible but this should be considered as a discussion document.
I envision the door would become a named object where the options where they apply would be radio buttons. the slide or hinge distance would be some offset either in degrees for swing and some distance for a slide