Blender for Korman For Beginners - A tutorial series
-
CalumTraveler
- Posts: 33
- Joined: Sat Feb 02, 2013 4:45 pm
-
CalumTraveler
- Posts: 33
- Joined: Sat Feb 02, 2013 4:45 pm
Re: Blender for Korman For Beginners - A tutorial series
Episode 13 is up,a bit shorter than usual due to some technical difficulties in design work that I'm going to revert and figure it wasnt worth showing.
Re: Blender for Korman For Beginners - A tutorial series
I started with Episode 1. It's a pleasure to watch.
Chacal
"The weak can never forgive. Forgiveness is an attribute of the strong."
-- Mahatma Gandhi
"The weak can never forgive. Forgiveness is an attribute of the strong."
-- Mahatma Gandhi
-
CalumTraveler
- Posts: 33
- Joined: Sat Feb 02, 2013 4:45 pm
Re: Blender for Korman For Beginners - A tutorial series
After about a Month and a Half of IRL Issues keeping my motivation to do one of these videos down low, I finally present to you all:EPISODE 14! Featuring some WIP shots of the Overflow Station.
-
CalumTraveler
- Posts: 33
- Joined: Sat Feb 02, 2013 4:45 pm
Re: Blender for Korman For Beginners - A tutorial series
After some lengthy delays in learning skills, the next four episodes are out.
EPISODE 15
EPISODE 16
EPISODE 17
EPISODE 18
EPISODE 15
EPISODE 16
EPISODE 17
EPISODE 18
-
CalumTraveler
- Posts: 33
- Joined: Sat Feb 02, 2013 4:45 pm
-
CalumTraveler
- Posts: 33
- Joined: Sat Feb 02, 2013 4:45 pm
Re: Blender for Korman For Beginners - A tutorial series
Apologies for the long delay, but the next episode is finally up- installation.
Episode 0.13:Install.
Episode 0.13:Install.
Re: Blender for Korman For Beginners - A tutorial series
Thanks a lot!
Chacal
"The weak can never forgive. Forgiveness is an attribute of the strong."
-- Mahatma Gandhi
"The weak can never forgive. Forgiveness is an attribute of the strong."
-- Mahatma Gandhi