PyPRP2 Questions from a Noob

[nathan2055]

Uh oh. I added the marker and some cones for fun:

This is my Blender window.

cubeage2.png (142.42 KiB) Viewed 4473 times

But after exporting my changes didn't appear! I looked in my dat folder and found two sets of files, I deleted them both (one was probably a leftover from when I was using another file name). The problem continues:

This is the Age in URU.

cubeage1.png (79.05 KiB) Viewed 4473 times

[Lontahv]

If you think it's PyPRP2's fault, you can PM me or post a link to your blend file. I'll take a look at it, try to export it, and tell you what's going on.

[Paradox]

I've had an issue in the past where after exporting an Age a bunch of times and loading it in Uru after every export, Uru would just stop loading new versions. I don't know if it was a file caching issue or something else, but even deleting the files and replacing them with the new ones didn't have any effect.

Like all problems on Windows, rebooting makes it work again.

[nathan2055]

I've had an issue in the past where after exporting an Age a bunch of times and loading it in Uru after every export, Uru would just stop loading new versions. I don't know if it was a file caching issue or something else, but even deleting the files and replacing them with the new ones didn't have any effect.

Like all problems on Windows, rebooting makes it work again.

OK, I'll try that.

If you think it's PyPRP2's fault, you can PM me or post a link to your blend file. I'll take a look at it, try to export it, and tell you what's going on.

If Paradox's suggestion doesn't work, I'll post the blend.

[nathan2055]

It didn't work . Here's the blend file:

Cube Age.blend

The blend file for my first Age, Cube Age.

(725.47 KiB) Downloaded 333 times

[tachzusamm]

Nathan, apply a material to the cones - it will work then

[nathan2055]

Edited the objects, I added material and colors. Exported and getting ready to link.

[nathan2055]

Edited the objects, I added material and colors. Exported and getting ready to link.

Linked in, and everything appeared fine! Here is a screenshot:

New screenshot!

cubeage1.png (101.31 KiB) Viewed 4423 times

I need to do something about that light though.

[Chacal]

Congrats! You have an Age.
The ground seems a little on the soft side, though.
I sink, therefore I am?

[Sirius]

LOL ! I would rather grab the spawn point 2 units higher.

Meshes without material are skipped during the export ? Or are they exported but the mat skipped ?
I remember the old version stopped working if there wasn't any material on a visible mesh.